DX-530 Portable Digital Flux Gate Meter
The power supply unit can supply power to the fluxgate and provide the same gate signal output interface. The acquisition unit can collect the fluxgate signal output by the power supply unit. The computer can read and save the data collected by the acquisition unit. The fluxgate probe can measure the data in the measuring range magnetic field, a series of supporting equipment and documents (power adapter of a portable computer, power adapter of acquisition card, bnc connecting wire, network cable, software instructions, schematic diagram of line connection, etc.), triangle bracket is used to fix the probe outdoors, data reading software is installed in the computer to read and collect data, so as to facilitate your accurate measurement.
Parameters
|
DX-530 Portable Digital Flux Gate Meter |
|
|---|---|
|
Acquisition frequency |
10-60k hz |
|
Resolution |
0.1nT |
|
Range |
±100μT/±1000μT |
|
Continuous working time |
Above 3 hours |
|
Number of data stores |
Save more than 10w pieces continuously by computer (depending on computer configuration) |
|
Laptop |
ThinkPad x270 |
|
Fluxgate probe |
Barrington mag-690 (it can be replaced in special use environments such as high temperature and waterproof) |
|
Suitcase size |
46*19*37cm |
Work information
The acquisition unit and the power supply unit are powered by the mobile power supply; the fluxgate probe is connected to the power supply unit through its own 15 pin connection line; the power supply unit is connected to the acquisition unit through three bnc signal lines; the acquisition unit is connected to the computer through the network cable; the computer is connected to the software connection acquisition unit for data reading; the computer can be charged through the mobile power supply when the computer power is insufficient.
Through the computer software, the real-time waveform and value can be observed, and the saved data can be viewed, exported, spectrum analysis and other operations.
